Are your fiberglass pool steps giving you trouble? Is there any damage to the material, such as fractures or chips? If that’s the scenario, you’ll have to learn how to repair fiberglass pool stairs.
The pool steps are among the main crucial parts of your swimming pool. They make it safe and straightforward to enter and exit the pool. However, when steps are not properly installed or maintained, they can become dangerous for swimmers.
Having a well-maintained pool with a proper water level is essential for safety. However, fiberglass pool steps absorb the heat and may cause the water to rise too high when access is from the bottom to the top. Consequently, you may install the fiberglass pool stairs in the following manner to avoid this.
Table of Contents
The Best Way to Fix Fiberglass Pool Steps
Among the most common issues, we see with fiberglass pools is the condition of the pool steps. Over time, weathering and general wear can cause these steps to become damaged, leading to a fall. Here are a few simple and frequent fixes for fiberglass pool stairs:
The first step in repairing the pool steps is to drain all the water. This will help you concentrate on the procedures by speeding up the drying process.
To remove water from your pool, you will need to drain it. Using a sump pump is the most basic method. You might also employ a wet/dry vacuum cleaner, assuming you have one.
The second step in repairing the stairs is to use fine-grit sandpaper to sand down the damaged region. Any loose or flaky material that has fallen off or chipped off can be removed by sanding the surface. Additionally, sanding the area will make it simpler to apply resin, which will fill in any gaps between the fiberglass strands that may have developed during the damage.
After that, you’ll need to fill in the cut-out region with a bond coat from the fiberglass repair kit. After that, you’ll need to put a coat of resin on top of it and let it cure for approximately an hour before proceeding to the next step.
Scrape away the old caulking in the cut-out area with a putty knife. Then, use a small amount of waterproof silicone sealant to fill the cut-out area.
You may start adding polyester putty once the bond layer has dried. The putty should first be catalyzed before it can be used. A catalyst, such as epoxy, must be applied to it. If you use an additional activator, the putty can dry extra hard. To use a spatula or a putty knife to level the putty will ensure a good application.
What Causes the Glass in Fiberglass Steps to Crack?
A few factors cause the glass in fiberglass steps to crack. The sun is the most prevalent culprit. The sun’s heat can cause the material to expand and contract, leading to cracks forming in the glass. Other causes of cracking include improper installation, poor quality materials, and chemical reactions with water or air.
Regular maintenance is necessary to keep the pool in excellent functioning order for various reasons. If the fiberglass pool steps are not properly and consistently maintained, they might become dangerous.
Leaving the water level too high might lead to erosion and cracking due to the increased heat. Hopefully, the preceding suggestions will help you figure out how to repair fiberglass pool stairs.